润滑薄油膜承载力的测量

李霞; 郭峰; 杨淑燕

润滑薄油膜承载力的测量

李霞¹,
郭峰^1, ,,
杨淑燕¹

青岛理工大学机械工程学院, 山东青岛 266033

基金项目:

国家自然科学基金(50875136)教育部博士点基金(20093721110001)资助.

详细信息

中图分类号: TH117
计量
- 文章访问数: 2566
- HTML全文浏览量: 10
- PDF下载量: 1909
出版历程
- 收稿日期: 2011-10-16
- 修回日期: 2011-12-06

Measurement of Load-carrying Capacity of Thin Lubricating Films

School of Mechanical Engineering Qingdao Technological University, Qingdao 266033, China

摘要

摘要: 利用面接触润滑油膜测量系统研究了固定倾角滑块轴承承载力问题.在滑块倾角和载荷固定不变的条件下测得油膜厚度与速度的关系,经过参数转换,得到无量纲承载量曲线.这不同于传统方法中在不同收敛比下对油膜压力的直接测量.结果表明:在薄油膜条件下实际承载量曲线和理论曲线表现了相同的变化趋势;实测值小于理论值;理论认为无量纲承载量唯一由收敛比决定,而实验结果表明无量纲承载量曲线受滑块倾角、载荷和润滑油性质的影响.
- 流体动压效应 /
- 承载量 /
- 收敛比 /
- 面接触
Abstract: The load-carrying capacity of a fixed-inclined slider bearing has been evaluated by film thickness measurement using an oil film thickness tester in conform contacts. In the measurement, under fixed inclination and load, film thickness values at different speeds are obtained, and the curve of load-carrying capacity is derived by a dimensionless parameter group. This approach is quite different from the previous methods whereby the pressure of oil film is measured under different convergence ratios and the load can be obtained by integration. The measured load-carrying capacity curve and the theoretical analysis show the same tendency, and however the measured value is lower than the theoretical value. The theory holds that the load-carrying capacity is determined only by the convergence ratio. However, the experimental results show the dimensionless load-carrying capacity is affected by the inclination angle of the slider, load and the properties of lubricating oils.
- hydrodynamic effect /
- load-carrying capacity /
- convergence ratio /
- conformal contact

HTML全文

参考文献(12)

[1]	Hamrock B J. Fundamentals of fluid film lubrication[M]. McGraw-Hill, New York,1994.
[2]	温诗铸. 摩擦学原理[M]. 北京:清华出版社,1990. Wen S Z. Principles of tribology[M]. Beijing:Tsinghua University Press, 1990.
[3]	D D Fuller. Theory and practice of lubrication for engineers[M]. John Wiley & Sons, Inc, US, 1984.
[4]	Andharia P I, Gupta J L, Deheri G M. Effect of surface roughness on hydrodynamic lubrication of slider bearings[J]. Tribology Transactions, 2001, 44: 291-297.
[5]	Hargeaves D J. Surface waviness effects on the load-carrying capacity of rectangular slider bearings[J].Wear, 1991,145:137-151.
[6]	刘红彬,牛荣军,薛玉君,等.表面纹理对径向滑动轴承油膜承载能力的影响[J].润滑与密封,2010,35(7):18-22. Liu H B, Niu R J, Xue Y J, et al. The effect of surface textures on loading capacity of journal bearing lubricating film[J]. Lubrication and Sealing, 2010,35(7):18-22.
[7]	刘红彬,孟永钢.基于区域分解法的纹理表面流体润滑分析-纹理分布模式的影响[J].摩擦学学报,2007,27(6):555-561. Liu H B, Meng Y G. Hydrodynamic lubrication analysis of textured surfaces with the domain decomposition method-effect of texture distribution patterns[J]. Tribology, 2007,27(6):555-561.
[8]	Buckholz R H. Effects of power-law non-Newtonian lubricants on load capacity and friction for plane slider bearing[J]. ASME Journal of Tribology, 108: 86-91.
[9]	Spikes H A.The half-wetting bearing[J]. Part 1: extended Reynolds equation. Proc Instn Mech Engrs, Part J: Journal of Engineering Tribology,2003,217:1-14.
[10]	Tonder K. Hydrodynamic effects of tailored inlet roughness: extended theory[J]. Tribology International 2004,37:137-142.
[11]	Sharma R K,Pandey. Experimental studies of pressure distributions in finite slider bearing with single continuous surface profiles on the pads[J]. Tribology International, 2009,42:1 040-1 045.
[12]	马冲,郭峰,付忠学,等.微型滑块面接触润滑油膜测量系统[J]. 摩擦学学报, 2010,30(4): 419-424. Ma C, Guo F, Fu Z X, et al. Measurement of lubricating oil film thickness in conformal contacts[J]. Tribology, 2010, 30(4): 419-424.